The maximum set temperature is approx. Safe and reliable, mechanical pressure switch. When the pressure is below the set value, the power supply is automatically switched off. Do not heat sea water or salt water. The thermostat must work with a water pump with an appropriate capacity.If the pump and thermostat do not match, the flow rate is too low, the heating pipe is dry and can easily be damaged. 5.5KW-15KW heaters must operate with a pump with a water flow of at least 177 ft³ / hour (5m³/hour). 18KW-36KW heaters must operate with a pump with a water flow of at least 353 ft³ / hour (10m³/hour). 40KW-60KW heaters must operate with a pump with a water flow of at least 530 ft³ / hour (15m³/hour). 1 kW is suitable for 1 ft³. 5.5KW thermostat is suitable for = 127 ft³ pool / 3.6m³. The 9KW thermostat is suitable for a pool with = 212 ft³ / 6m³. The 11KW thermostat is suitable for a pool with = 259 ft³ / 7.3m³.
The 15KW thermostat is suitable for a pool of = 353 ft³ / 10m³. The 18KW thermostat is suitable for a pool with = 424 ft³ / 12m³. It is recommended to use the thermostat with a circulating water pump.
Operating procedure: first turn on the water pump and then the thermostat. Shutdown: First turn off the thermostat, wait a while (10 seconds to 1 minute depending on the performance of the thermostat) and then turn off the pump. Reliable leak protection devices must be installed and commissioned by the responsible electrician. The additional heating effect of the thermostat is better. Direct heating requires the use of a more powerful machine.
Prevent water from burning dry and protect the pool heater from overheating. Automatic shutdown in case of lack of water. The thermostat will not work if the pump does not start.It can effectively prevent water shortage and non-standard operation from damaging the machine. It will turn off automatically when the temperature reaches the temperature, and it can automatically start the heating function after the temperature is lowered, which can effectively prevent damage from excessive machine temperature. If the current is too large, the circuit breaker is immediately disconnected and the power supply interrupted. Use the AC contactor as a start switch. Regardless of the type of accident, you can quickly disconnect the power supply and protect the safety of the machine and people. The control system continuesly monitors the operating status of all parts of the heater and reacts quickly and displays appropriate notification messages for each event to prevent from damage or malfunctions.
If an error occurs, the pool heater will stop immediately and a message will appear on the control panel so that the user or technician can determine where the error is. The safety of the customer is a top priority. Liner material: stainless steel Voltage: 220V (Transformer required) Power: 18KW Phase: single phase Connection size: 40 mm (1.57) Machine size: 49 x 10 x 38 cm / L x W x H.Suitable for: hot tub & swimming pool equipment. 1 pool heater 1 English manual.
We are not responsible for undeliverable address. X'mas or other reasons. Your patience is always appreciated. Dear friend: Welcome to me my services are available: Monday To Friday: 8:30 to 18:00 (Beijing China time) 1. If it's non-workdays, please kindly be patient and considerable to give us a little more time.This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Pool Equipment & Parts\Pool Heaters & Solar Panels". The seller is "qwegggss666" and is located in this country: US. This item can be shipped to United States.